RFLink Gateway USB: Difference between revisions
Jump to navigation
Jump to search
m →Setup |
|||
| Line 16: | Line 16: | ||
* Go to Setup -> Hardware | * Go to Setup -> Hardware | ||
* Select Type: RFLink Gateway USB | * Select Type: RFLink Gateway USB | ||
* Select correct com port (on rpi ex. /dev/ | * Select correct com port (on rpi ex. /dev/serial/by-id/.....) | ||
* Give it a name. Ex RfLink433 | * Give it a name. Ex RfLink433 | ||
* Push Add | * Push Add | ||
Now if you have "Accept new hardware" enabled under settings, it should start to populate the device list with new devices. Add them by the green arrow. | Now if you have "Accept new hardware" enabled under settings, it should start to populate the device list with new devices. Add them by the green arrow. | ||
Latest revision as of 15:51, 28 March 2025
Introduction
RfLink is a modular radio gateway for your 433Mhz devices. And also some other bands depending on what radio module it's equipped with.
It can be bought somewhat assembled in a kit or you can build it from scratch.
It uses an arduino mega shield as a base and adds a shield for radio stuff
See RFLink Hardware
List of supported devices by RfLink
Shields and kits can be bought from nodo-shop and the firmware downloaded from here (please support the devs)
Setup
First Plugin you RFLink to your Domoticz machine
- Go to Setup -> Hardware
- Select Type: RFLink Gateway USB
- Select correct com port (on rpi ex. /dev/serial/by-id/.....)
- Give it a name. Ex RfLink433
- Push Add
Now if you have "Accept new hardware" enabled under settings, it should start to populate the device list with new devices. Add them by the green arrow.